SACC-M12FRD-4Q SH - Data connector

1553637

Data connector, Ethernet CAT5 (100 Mbps), 4-position, shielded, Socket angled M12, coding: D, Insulation displacement connection, knurl material: Brass, nickel-plated, external cable diameter 4 mm ... 8 mm

Assembly note NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Assembly note The connector pin assignment can be rotated 45° to the cable outlet

Product type Circular connector (cable-side)
Application Data
Sensor type Ethernet
Number of positions 4
No. of cable outlets 1
Shielded yes
Coding D
Cable outlet angled
Insulation characteristics
Overvoltage category II
Degree of pollution 3

External dimensions
Outside diameter 4 mm ... 8 mm

Flammability rating according to UL 94 V0
Seal material Neoprene
Material of grip body Zinc die-cast, nickel-plated
Contact material CuSn
Contact surface material Ni/Au
Contact carrier material PA 6
Material for screw connection Brass, nickel-plated

Conductor connection
Connection method Insulation displacement connection
Connection cross section 0.14 mm² ... 0.34 mm²
Connection cross section AWG 26 ... 22
Tightening torque 0.4 Nm (M12 knurl)
0.8 Nm (Connector with coupling sleeve)
3 Nm (Pressure nut with coupling sleeve)

Contact resistance ≤ 5 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 1.75 A

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Socket
Head cable outlet angled
Head thread type M12
Coding D

Signal type/category Ethernet CAT5 (based on IEC 11801), 100 Mbps

Ambient conditions
Degree of protection IP67
Ambient temperature (operation) -40 °C ... 85 °C

M12
Standard designation M12 connector
Standards/specifications according to IEC 61076-2-101